Decisions decisions. need load advice.

1
New loader here. I just finished loading the last of 500 of my Berry's 9mm 124gr RN bullets. I just received 500 count of 9mm flat point .356 dia. Bear Creek bullets. They are moly coated. I am wondering if it might not be too early given my experience to load such a bullet.
Here's the data I have found so far for starting loads:
Lyman manual 147 gr #2 alloy, 1.058 oal, 2.5 gr titegroup
Lyman manual 147 gr TMJ , 1.115 oal, 3.2 gr titegroup
Lee Manual 147 gr XTP, 1.100 oal, 3.2 gr titegroup

If I was to go ahead without asking for advice I would go for the "147 gr #2 alloy, 1.058 oal, 2.5 gr titegroup" since it has the weakest load of them all. But I don't want to risk another squib load.
What are moly coated bullets comparable to? Does any body have another source of data?

Who is online

Users browsing this forum: No registered users and 3 guests