Ruger PC Carbine Stocks

1
So, I finally broke down and bought one of these ugly SOB's. I am running out of 9mm carbines to buy and tinker with. I was looking for an Archangel pistol grip, but they appear to be out of stock everywhere. That's when I ran across this beauty on a REDDIT thread. I am not that technical to carve one out myself, but if there where someone I could be introduced to, that would be fantastic!
Ruger PCC.JPG
Never confuse knowledge with intelligence.

Re: Ruger PC Carbine Stocks

8
Update.
I finally finished my project. I gave up trying to find a surplus PPSH stock.
The artist at my LGS is blessed with talent. That is the original poly-stock.
Take a look at the wood grain finish (Yes, it's paint).
My last task is that I am going to 3D print a spacer to fill the gap between the drum mag and the mag well.
For reference, that's a Glock 43 drum mag, slightly shorter then regular 17/19.
Ruger PCC .jpg
Never confuse knowledge with intelligence.

Re: Ruger PC Carbine Stocks

12
FlyGuy wrote: Thu Oct 14, 2021 9:13 am Update.
I finally finished my project. I gave up trying to find a surplus PPSH stock.
The artist at my LGS is blessed with talent. That is the original poly-stock.
Take a look at the wood grain finish (Yes, it's paint).
My last task is that I am going to 3D print a spacer to fill the gap between the drum mag and the mag well.
For reference, that's a Glock 43 drum mag, slightly shorter then regular 17/19.
Ruger PCC .jpg
Okay that's just cool!!
“I think there’s a right-wing conspiracy to promote the idea of a left-wing conspiracy”

Who is online

Users browsing this forum: No registered users and 3 guests